Voodoo vibe Jr features:

MULTI-MODE OUTPUTS with HARD WIRE BYPASS or TWO BUFFERED OUTPUTS

The Voodoo-Vibe Jr has three outputs, a true hard wire output plus two buffered outputs that can drive long cable lengths with no high frequency loss. These two buffered outputs are identical and are disconnected when the hard wire output is being used. This means that you have a choice for all possible performance or equipment situations whether you feel a true hard wire output or buffered outputs will perform best. In general the low output impedance of the buffer gives a lower noise floor and a more punchy sound but now it's so easy to hear the difference and make a real decision that is based on fact not hype.

Technical Description:

MODE 1: There is no jack plug inserted into the Hard Wire Output ( HW OUT1 ).

The input of the buffer is connected through switching contacts on this jack socket (HW OUT1) to the foot switching output ( "full bypass" or "effect" ) and the two buffer outputs (BF OUT2) and (BF OUT3) will thus follow the foot switching action. In this "bypass mode" however the input of the buffer is only connected to the Input jack socket of the unit and not to the Vibe circuit as well so it can be thought of as "full bypass buffered".

MODE 2: When a jack is inserted into the Hard Wire Output (HW OUT1).

The input of the buffer is disconnected and no output signal will appear at the two buffered outputs. The Hard Wire Output (HW OUT1) will follow the foot switching output ( "full bypass" or "effect" ). In this "bypass mode" the Hard Wire Output (HW OUT1) is directly connected to the Input jack socket and to nothing else in the unit and is in "full bypass" - "true bypass" or "hard wire bypass" mode as the input is directly connected to the output through the foot switch and to nothing else.

LED : An LED shows the status of the effect. The LED also shows a low battery condition and will fail to light in either status thus showing that battery replacement is required.
RAPID BATTERY CHANGE : No more screws to loose!. Slide the front panel back and there is the battery. It could not be simpler or faster.

LONG BATTERY LIFE : Exceptionally low current consumption: Bypass Mode=12mA. Effect Mode=15mA ensures an expected battery life of more than 20Hrs with alkaline type batteries.

EXTERNAL POWER ADAPTER / SUPPLY : An external AC adapter (not supplied) can be used and access is through a standard DC power jack ( 2.1mm centre pin ) situated next to the jack sockets. Internal onboard filtering ensures that optimum low noise performance is maintained and diode protection provides peace of mind in case of polarity setting mistakes.

Connection protocol: It uses the standard negative centre pin connection protocol used by many leading manufacturers.

Specifications: 9 volt DC. Regulated output is recommended.

Current rating: 50mA or more.

ERGONOMIC DESIGN / PEDAL BOARD FRIENDLY : The position of the jack sockets and DC power jack are all on the same side of the enclosure and face away from you thus enabling the effect to be optimally positioned in pedal board set-ups.

DIMENSIONS: Width 170 x Depth 112 x Height 57mm. (6.7"W x 4.4"D x 2.25"H)

WEIGHT : 618g (1.4 lbs.) with battery.