* Limited Qty's!
Unique wavetable VCO with 2 independent waveform outputs.
What sets the E350 apart from previous wavetable oscillators is the voltage-controlled two-dimensional morphing.
Sound is really good and clear.
The module ships with 3 banks of 64 'basic' waveforms (192 total).
Each bank of 64 waves is arranged in memory as an 8 x8 array, like a chess board.
The 'rows' are called 'the x direction' and the columns are 'the y direction'.
The 2 panel controls and the 2 external control voltages (morph X and morph Y) scan the two axes.
The third control voltage is called 'z morph', and it determines the waveshape at the Z out.
The z control voltage 'scans' then wavetable bank from wave #1 (think as row 1, column 1) to wave #64 (row 8, column 8).
For example: if X morph is set to 2, and Y morph is set to 5, the signal at XY out is the waveform stored at row 2, column 5 (the 13th wavetable). The Z out is completely independent of xy out, so if the morph Z knob is at 48, then the 48th wavetable (row 6, column 8) is the output
coarse/fine - initial frequency of the vco
FM: attenuates the voltage on the fm jack 0-100%
Morph Y - sets the starting point of the XY out waveshape in a row
Morph Y - sets the starting point of the XY out waveshape in a column
Morph Z - sets the starting point of the Z out waveshape (scans the entire bank)
Bank - selects the A (sine/hammond organs), B (widely varies) or C (lfo shapes/noise) wavetable bank
Range - selects the operating range of the vco frequency
Manhattan Analog's MTX is an expander module for the Morphing Terraium bringing jumper-selectable functions to the front.
1V/octave input and FM input for frequency control. sync input
Morph CV inputs for X, Y and Z
audio outputs for XY and Z
3U Eurorack module, 14HP wide, 30mm deep. Current draw 55mA@ +12V and 25mA@ -12V