Two Notes Audio Engineering, creator of the world’s best speaker cabinet simulation, has bridged a new technological gap with the Torpedo Reload, your new high-end device for silent playing and reamplification.
The Reload is the ideal combination of the devices you must have in a modern studio for the recording of electric guitars and basses: a power attenuator, a multi-impedance loadbox, a DI and re-amping box – it does it all and does it perfectly too.
The Two Notes philosophy stands in one word, transparency. The tone must come from your guitar, your amp and cabinet – not from the electronics that we put between parts of your regular setup.
Attenuators are usually known for the negative impact they have on your tone in cases of heavy attenuation. On the contrary, the Reactive-Active technology presents your amplifier with a consistent speaker’s impedance no matter what level of attenuation you’re at, and thus preserves the specific character of your amplifier. With a choice of 4, 8, or 16 Ohms, your amplifier (up to 150W RMS) will actually see real speaker impedance, and your tone will remain constant throughout the continuous attenuation curve.
Transparency is the key.
The result of years of research, the RE-ACTTM technology (Reactive-Active Attenuator) will tame your amplifier without ever betraying it.
From 0dB attenuation to total silencing, you can nonetheless choose between absolute transparency to more vintage or modern tone coloring with the CONTOUR.
Unlike other attenuators that may “show” your amplifier a higher impedance and thereby crush its tone, the Reload offers constant loadbox impedance which is similar to a speaker’s, and which is low enough to drive the speaker in the most respectful way possible. The tone picked up by the loadbox is therefore transmitted to the speaker without any modification.
Admissible power: 150W RMS, 200W peak.
Inputs can handle both balanced and unbalanced signals.
DI and Loadbox Outputs are electronically balanced using low-noise, low-distortion circuits so your tone will never be affected by any kind of unwanted artifacts. They are also protected against 48V Phantom power, in case you forget to switch it off on the mixer.
The REPLAYTM Output follows a low-impedance unbalanced design to ensure the best conditions when sending the signal to the amplifier.